SENSOR, Knock: Removal: 5.7L
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Two knock sensors (1) are used. Each sensor is bolted to the outside of the cylinder block below the exhaust manifold(s) (3).
- Raise and support the vehicle.
- Disconnect the knock sensor electrical connector(s) (5).
- Remove the knock sensor retaining bolt(s) (2).NOTE:
Note the foam strip on bolt threads. This foam strip is used only to retain the bolts to the sensors for plant assembly. It is not used as a sealant. Do not apply any adhesive, sealant or thread locking compound to these bolts.
- Remove the knock sensor(s) (1) from the cylinder block.