COIL, Ignition: Installation: 5.7L

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/installing Ignition Coil

Courtesy of CHRYSLER LLC

Using compressed air, blow out any dirt or contaminants from around top of spark plug.
NOTE:
Use dielectric grease on each of the spark plug boots before installing the coil.
Position ignition coil (1) into valve cover and push onto spark plugs.

Fig 2: Identifying 5.7l Ignition Coil
Courtesy of CHRYSLER LLC
Install 2 coil mounting bolts (2). Tighten to 7N.m (62 in.lbs).
Connect electrical connector (1) to coil by snapping into position.