Section 458 (Audio/Video/Entertainment/Connectivity (Service Information)): Radio: Description: Description

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Interaction with the radio features is done through the ISC screen module and switch bank located in the center stack of the instrument panel.

RADIO ANTI-THEFT CODE PROCEDURE The following is for vehicles that are equipped with power net or NTG4 radios. If the TGM or the radio have been removed or replaced, a four digit security code is required in order for the radio to function:

The key must be in the "RUN" position.
Press the "ON/VOL" control button.
The word "CODE" or " Please enter Anti-Theft Code" will appear on the display.
Enter the 4-digit code by pressing the corresponding preset buttons in sequence.

NOTE:

If three consecutive attempts are made to enter an invalid anti-theft code the radio will enter a 'WAIT' state. While in this state the radio display will read 'WAIT'. To exit the 'WAIT' state the radio must remain powered with the ignition in the run position for a continuous 30 minutes (the vehicle may be driven during this time). After exiting the 'WAIT' state the radio will again display 'CODE' and a valid anti-theft code may be entered.