LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Restraints System (Service Information)) >> Retractor, Seat Belt, Second Row >> Removal >> Rear - Outboard

Rear - Outboard

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Rear Seat Belt Retractor
GC0122067Courtesy of CHRYSLER GROUP, LLC
  1. Remove rear seat cushion. Refer to COVER, SEAT CUSHION, REMOVAL , COVER, SEAT CUSHION, FRONT, REMOVAL or COVER, SEAT CUSHION, REMOVAL .
  2. Remove bolt (4) attaching seat belt anchor to floor pan.
  3. Remove upper and lower quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
  4. Feed seat belt webbing through upper quarter trim panel (3).
  5. Remove turning loop bolt (2) to quarter upper panel (1).
  6. Remove bolt (5) attaching rear seat belt retractor (6) to inner quarter panel (1).
  7. Remove retractor and belt (6) from vehicle.
scientia non olet · About LEMON Manuals