LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Restraints System (Service Information)) >> Retractor, Seat Belt, Rear Center >> Installation >> Rear - Center

Rear - Center

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Rear Seat Belt Buckle
GC0122053Courtesy of CHRYSLER GROUP, LLC
WARNING:

Inspect the condition of the shoulder/lap belt. Replace the retractor if the belt is cut, frayed, torn, or damaged in any way. Failure to inspect the belts could result in improper restraint and could cause occupant serious or fatal injury.

  1. Route webbing and bezel through rear shelf trim panel.
  2. Install the seat belt anchor and buckle (4) onto the stud.
  3. Install nut and tighten to 101 N.m (74.5 ft. lbs.).
    Fig 2: Removing/Installing Rear Center Seat Belt Retract
    GC0122066Courtesy of CHRYSLER GROUP, LLC
  4. Install the center rear seat belt retractor assembly on the rear shelf. Tighten the bolt to 37 N.m (27 ft. lbs.).
  5. Install the rear shelf trim panel. Refer to PANEL, REAR SHELF, INSTALLATION .
scientia non olet · About LEMON Manuals