Standard Procedure - Quick Connect Fitting Disassembly/Assembly: Disconnect
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- Remove dust cap by pulling it straight back off of quick connect fitting
- Place disconnect Special Tool 8875A onto a . inch transmission cooler lines or Special Tool 9546 onto a . inch transmission cooler lines with the fingers of the tool facing the quick connect fitting.
- Slide disconnect tool down the transmission line and engage the fingers of the tool into the retaining clip. When properly engaged in the clip, the tool will fit flush against the quick connect fitting.
- Rotate the disconnect tool 60° to expand the retaining clip.
- While holding the disconnect tool against the quick connect fitting, pull back on the transmission cooler line to remove.