Header Weatherstrip

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Foam & Header Weatherstrip

Courtesy of CHRYSLER GROUP, LLC

Place top into vertical position. Refer to DECKLID/HATCH/LIFTGATE/TAILGATE .
Start with one end of the header weatherstrip and lift up to remove weatherstrip from tape (2).
Carefully remove the weatherstrip by lifting up on the weatherstrip moving down the A-Pillar.
Carefully remove the header weatherstrip from the retainer going across the header.
Carefully remove the weatherstrip by lifting up on the weatherstrip moving down the other A-Pillar.
Remove any foam (1) left on header sheet metal.
Clean header and A-Pillar.