Sleeve, Headrest: Removal: Removal
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the seat from vehicle. Refer to SEAT, REMOVAL - SEATS, FRONT SEDAN or SEAT, FRONT, REMOVAL - SEATS, FRONT CONVERTIBLE.
- Remove the seat back from the seat frame. Refer to RECLINER, SEAT BACK, FRONT, REMOVAL .
- Remove the seat back cover panel by carefully prying out the lower end of the cover and disengaging the bottom and side spring clip retainers.
- Once the four spring clip retainers are disengaged, push upward on the cover toward the top of the seat back, and pull the top of the cover outward to disengage from the spring retainers.
- Remove the two lower push-pins securing the seat cover.
- Disengage the J-hooks securing the seat back cover to the frame.
- Remove the black foam from under the seat back cover.
- While squeezing the tabs on the headrest sleeves, gently tap the bottom of the sleeve with a rubber mallet and remove from the seat back.