LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Lamps/Lighting - Exterior (Service Information)) >> Unit, Front Lamp >> Removal >> Bulbs >> Dodge >> Headlamp

Unit, Front Lamp: Removal: Bulbs: Dodge: Headlamp

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

  1. Disconnect and isolate the battery negative cable.
  2. Reach behind the front lamp unit to access the bulbs from the back of the lamp housing.
  3. Disconnect the Front End Module (FEM) wire harness connector from the headlamp high beam (1) or low beam (2) bulb connector receptacle (3).
  4. Firmly grasp the high beam or low beam bulb base on the back of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
  5. Pull the bulb and base straight out from the keyed opening in the reflector.
scientia non olet · About LEMON Manuals