LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Lamps/Lighting - Exterior (Service Information)) >> Unit, Front Lamp >> Installation >> Lamp

Unit, Front Lamp: Installation: Lamp

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Chrysler
GC0147118Courtesy of CHRYSLER GROUP, LLC
Fig 2: Dodge
GC0147119Courtesy of CHRYSLER GROUP, LLC
NOTE:

If replacing the front lamp with a new unit, the bulbs must be transferred.

  1. Position the front lamp unit (1) close enough to the front of the vehicle to reconnect the Front End Module (FEM) wire harness connections to the back of the lamp housing.
  2. Position the lamp to the FEM support structure on the front of the vehicle.
  3. Install and tighten the screw (2) that secures the upper outboard mounting tab of the lamp housing to the FEM upper support cross member. Tighten the screw securely.
    Fig 3: Chrysler
    GC0147116Courtesy of CHRYSLER GROUP, LLC
    Fig 4: Dodge
    GC0147117Courtesy of CHRYSLER GROUP, LLC
  4. Install and tighten the two screws (1 and 3) that secure the front lamp unit (2) mounting tabs to the FEM support. Tighten the screws securely.
  5. Position the front fascia bracket (5) onto the FEM support below the front lamp unit.
  6. Install and tighten the two screws (4) that secure the front fascia bracket the FEM support.
    Fig 5: Chrysler
    GC0147114Courtesy of CHRYSLER GROUP, LLC
    Fig 6: Dodge
    GC0147115Courtesy of CHRYSLER GROUP, LLC
  7. Install and tighten the screw (2) that secures the outboard side of the front lamp unit (1) to the front fender forward of the front wheel opening.
    Fig 7: Chrysler
    GC0147112Courtesy of CHRYSLER GROUP, LLC
    Fig 8: Dodge
    GC0147113Courtesy of CHRYSLER GROUP, LLC
  8. Snap the side fascia bracket (1) onto the front fender forward of the front wheel opening.
  9. Install and tighten the two screws (2) that secure the side fascia bracket to the front fender. Tighten the screws securely.
  10. Engage the upper edge of the front fascia with the side and front fascia brackets on the same side of the vehicle as the front lamp unit being serviced. Refer to FASCIA, FRONT, INSTALLATION .
  11. Reconnect the battery negative cable.
  12. Confirm proper headlamp alignment. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals