Lamp, Tail Stop Turn: Installation: Bulb
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
- Align the base of the bulb with the bulb socket (2).
- Push the bulb straight into the socket until the base is firmly seated.
- Align the socket and bulb with the keyed opening on the back of the rear lamp unit (1) housing.
- Insert the socket and bulb into the housing until the socket is firmly seated.
- Rotate the socket clockwise about 30 degrees to lock it into place.
- Reinstall the rear lamp unit onto the vehicle. Refer to LAMP, TAIL STOP TURN, INSTALLATION .
- Reconnect the battery negative cable.