LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 449 (Heating & Air Conditioning (Service Information)) >> Distribution >> Housing, HVAC >> Removal >> Housing-Air Inlet

Housing-Air Inlet

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

WARNING:

Refer to the applicable Warnings and Cautions for this system before performing the following operation. Refer to WARNING  and CAUTION . Failure to follow these instructions may result in possible serious or fatal injury.

NOTE:

The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.

NOTE:

LHD model shown in illustration. RHD model similar.

Fig 1: Air Inlet Housing, Tabs & Screws
GC0082721Courtesy of CHRYSLER GROUP, LLC
  1. Remove the HVAC housing assembly and place it on a workbench. Refer to HOUSING, HVAC, REMOVAL .
  2. If equipped, remove the cabin air filter. Refer to FILTER, CABIN AIR, REMOVAL .
  3. Remove the four screws (1) that secure the air inlet housing (2) to the top of the HVAC housing (3).
  4. Disengage the two plastic retaining tabs (4) that secure the air inlet housing to the HVAC housing and remove the inlet housing from the HVAC housing.
  5. If required, disassemble the air inlet housing. Refer to HOUSING, HVAC, DISASSEMBLY .
scientia non olet · About LEMON Manuals