LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 448 (Steering System) >> Pump >> Hose, Power Steering, Pressure >> Removal >> Right-Hand-Drive - 2.4L Engine

Right-Hand-Drive - 2.4L Engine

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Before proceeding. Refer to WARNING .

Fig 1: Power Steering Pressure Hose
GC0082505Courtesy of CHRYSLER GROUP, LLC
  1. Siphon as much fluid as possible from the power steering fluid reservoir.
  2. Remove the engine appearance cover.
  3. Remove the pressure Hose (3) at the pump pressure port (5).
  4. Remove the pressure hose routing bracket bolt (2) at the upper mount (8).
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    Fig 2: Hoses At RHD Gear
    GC0098924Courtesy of CHRYSLER GROUP, LLC
  6. Unthread the tube nut (2) and remove the pressure hose at the steering gear.
  7. Remove the power steering pressure hose from the vehicle.
scientia non olet · About LEMON Manuals