Fascia, Rear: Removal: Avenger

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Fascia Push Pins

Courtesy of CHRYSLER GROUP, LLC

Open decklid.
Remove upper fascia push pins (1).
Raise vehicle.

Fig 2: Lower Fascia Push Pins
Courtesy of CHRYSLER GROUP, LLC
Remove lower fascia push pins (1).
Remove left and right splash shield push pins and fasteners.

Fig 3: Rear Fascia Fastener
Courtesy of CHRYSLER GROUP, LLC
Remove fascia fastener (2).
Slide fascia rearward from push pins (1).

Fig 4: Wire Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect wire connector (1) and (2).