LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 446 (Frame And Bumpers) >> Bumpers >> Fascia, Rear >> Installation >> SEBRING Sedan

SEBRING Sedan

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Fascia Push-In Fasteners
GC0122080Courtesy of CHRYSLER GROUP, LLC
  1. Ensure that the energy management foam is properly installed in rear fascia.
  2. Position fascia on vehicle.
  3. Slide fascia forward to engage hooks attaching fascia to bottom of quarter panel.
  4. Install push-in fasteners (1) attaching center of fascia to trunk opening.
  5. Install screws (2) attaching fascia to quarter panel at wheelhouse opening.
    Fig 2: Lower Fascia Fasteners
    GC0122082Courtesy of CHRYSLER GROUP, LLC
  6. Install lower fascia fasteners.
  7. Install fasteners attaching rear splash shields to wheelhouse.
scientia non olet · About LEMON Manuals