Fascia, Rear: Installation: Avenger

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wire Connector

Courtesy of CHRYSLER GROUP, LLC

Raise vehicle.
Connect license plate wire connectors (1) and (2).

Fig 2: Rear Fascia Fastener
Courtesy of CHRYSLER GROUP, LLC
Slide rear fascia onto fascia locators (1).
Install fastener (2).
Install left and right splash shield push pins and fasteners.

Fig 3: Lower Fascia Push Pins
Courtesy of CHRYSLER GROUP, LLC
Install lower fascia push pins (1).
Lower vehicle.
Raise decklid.

Fig 4: Rear Fascia Push Pins
Courtesy of CHRYSLER GROUP, LLC
Install upper fascia push pins.