Switch, Oil Pressure: Removal: Removal
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Raise and support the vehicle Refer to HOISTING, STANDARD PROCEDURE .
- Remove the splash shield from the right side frame rail Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
- Remove the accessory drive belt Refer to BELT, SERPENTINE, REMOVAL .
- Remove the three bolts (2) and reposition the A/C compressor (1).
- Disconnect the oil pressure switch electrical connector.
- Remove the oil pressure switch using oil pressure socket (special tool #C-4597, Socket, Oil Pressure) (1) or equivalent.