Switch, Brake Fluid Level: Removal: Removal

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before proceeding, refer to WARNING .

Fig 1: Identifying Brake Fluid Level Switch Connector

Courtesy of CHRYSLER GROUP, LLC

Remove the wiring harness connector (1) from the brake fluid level switch (2) in the master cylinder brake fluid reservoir.

Fig 2: Level Switch Retaining Tabs
Courtesy of CHRYSLER GROUP, LLC
Push together the retaining tabs (1) holding the brake fluid level switch in place in the brake fluid reservoir (2).
Pull the brake fluid level switch out the right side of the reservoir.