LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Base Brakes (Service Information)) >> Electrical >> Switch, Brake Fluid Level >> Installation >> Installation

Switch, Brake Fluid Level: Installation: Installation

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Level Switch Retaining Tabs
GC0082334Courtesy of CHRYSLER GROUP, LLC
  1. Align the brake fluid level switch with its mounting hole on the right side of the master cylinder brake fluid reservoir. Push the switch into the fluid reservoir until the switch retaining tabs (1) are expanded on the opposite side of the reservoir (2), locking it in place.
    Fig 2: Identifying Brake Fluid Level Switch Connector
    GC0120811Courtesy of CHRYSLER GROUP, LLC
  2. Connect the wiring harness connector (1) to the switch (2).
scientia non olet · About LEMON Manuals