LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 433 (6.7L Diesel - DTCS P0008 To P040D - 2500 Hd & 3500 Hd) >> Diagnosis And Testing >> P02E2-Diesel Intake Air Flow Control Circuit Low >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. DTC ACTIVE 
    1. Turn the ignition on.
    2. With the scan tool, record all Freeze frame data.
    3. With the scan tool, erase DTCs.
    4. Turn the ignition off for 75 seconds.
    5. Start the engine and let idle for one minute.
    6. With the scan tool, read DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

  2. CHECK THE (K674) AIR INTAKE THROTTLE MOTOR (-) CIRCUIT FOR A SHORT TO GROUND 
    1. Turn the ignition off.
    2. Disconnect the EGR Airflow Control Valve harness connector.
    3. Disconnect the PCM C1 harness connector.
    4. Measure the resistance between ground and the (K674) Air Intake Throttle Motor (-) circuit at the EGR Airflow Control Valve harness connector.

      Is the resistance below 10k Ohms?

      Yes 

      • Repair the (K674) Air Intake Throttle Motor (-) circuit for a short to ground.
      • Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .

      No 

      • Go To  3
  3. CHECK THE (K673) AIR INTAKE THROTTLE MOTOR (+) CIRCUIT FOR A SHORT TO GROUND 
    1. Measure the resistance between ground and the (K673) Air Intake Throttle Motor (+) circuit at the EGR Airflow Control Valve harness connector.

      Is the resistance below 10k Ohms?

      Yes 

      • Repair the (K673) Air Intake Throttle Motor (+) circuit for a short to ground.
      • Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .

      No 

      • Go To  4
  4. EGR AIRFLOW CONTROL VALVE 
    1. Replace the EGR Airflow Control Valve in accordance with the Service Information. 
    2. Reconnect the EGR Airflow Control Valve harness connector.
    3. Reconnect the PCM C1 harness connector.
    4. Turn the ignition on.
    5. With the scan tool, erase DTCs.
    6. Start the engine and allow it to idle for one minute.
    7. With the scan tool, read DTCs.

      Did the DTC return?

      Yes 

      • Replace Powertrain Control Module in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .

      No 

      • Repair complete.
      • Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals