Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

OTHER DTCS
1. Ignition on, engine not running.
2. With the scan tool, read DTCs.
  Is U010C active?
  
  Yes
  - Repair U010C first.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
ELECTRONIC TURBO ACTUATOR
1. Turn ignition off.
2. Disconnect the Electronic Turbo Actuator harness connector.
  NOTE:
  Check connectors - Clean/repair as necessary.
  
  Are there dirty or damaged pins?
  
  Yes
  - Repair/Replace as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Replace the Turbocharger Assembly in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .