Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE WIRING AND CONNECTORS
1. Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage or terminal push out. Pay particular attention to all power and ground circuits.
2. Wiggle the wires while checking for shorted and open circuits.
3. Check Service Bulletins that may apply.
  Were there any problems found?
  
  Yes
  - Repair the power and/or ground circuits as necessary.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the PCM in accordance with the Service Information. With the scan tool, perform Quick Learn.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .