Diagnostic Test
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- ACTIVE DTC NOTE:
Diagnose and repair any Starter Relay circuit faults that are present in the PCM or BCM before continuing with this test procedure.
- Start the engine and allow it to idle.
- With the scan tool, read DTCs.
Is the DTC active?
Yes
- Replace the Starter Relay 2.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .