Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, erase DTCs in the BCM.
3. Cycle the ignition on and off several times, leaving the ignition on for at least 20 seconds during each ignition cycle.
4. Turn the ignition on.
5. With the scan tool, view DTCs in the BCM.
  Is the DTC active?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .