Set Condition
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
When the Powertrain Control Module (PCM) recognizes Brake Switch voltage is not equal to the applied value at the PCM when Brake Switch is applied. This could be a normal condition. If this condition is seen repeatedly by the PCM the fault is set. Cruise will not work for the rest of the key cycle. One trip fault. If the vehicle is equipped with the stop/start feature, the system will be disabled when this DTC is active.