LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (5.7L - DTCS P0205 To P058B - 2500 Hd & 3500 Hd) >> Diagnosis And Testing >> P0330-Knock Sensor 2 Circuit >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

The Powertrain Control Module (PCM) detects that the Knock Sensor input voltage is: Above 4.0 Volts, less than or equal to 1.0 Volt with engine RPM at or above 2200 or equal to 0.0 Volts with engine RPM below 2200. Two Trip Fault. Three good trips to turn off the MIL.

scientia non olet · About LEMON Manuals