Theory Of Operation

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

When the Powertrain Control Module (PCM) receives a 'Start' or 'Run' signal from the ignition; It energizes the Fuel Pump relay which sends a continuous 12 volt supply to the Fuel Pump Control Module (FPCM). The PCM also sends a control signal directly to the FPCM which regulates the Pulse Width Modulated (PWM) voltage that will be sent to the Fuel Pump Module. The PWM will vary from 10-100% depending on the input of the Fuel Rail Pressure sensor and other engine demands. The Powertrain Control Module (PCM) receives a Pulse Width Modulated (PWM) signal from the Fuel Pump Control Module (FPCM) representing the state of all inputs and outputs of the FPCM. This is a Constant Pressure Fuel system which means any Delta Pressure test performed on the Fuel Pump would show a continuous pressure (regardless of the changes in PWM). If a pressure sensor fails or other failures are present; The duty cycle goes to Limp mode (100%) to maintain fuel pressure.