LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 418 (5.7L CNG - DTCS P060B To P2128 - 2500 Hd) >> Diagnosis And Testing >> P0632-Odometer Not Programmed In Pcm >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 2500 HD and 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. PROGRAMMING MILEAGE INTO THE PCM 
    1. Ignition on, engine not running.
    2. With the scan tool, erase DTCs.
    3. Using a scan tool, program the mileage into the PCM.
    4. Start the engine.
    5. Allow the engine to reach normal operating temperature.
    6. With the scan tool, select View DTCs.

      Does the DTC reset?

      Yes 

      • Replace and program the Powertrain Control Module in accordance with the Service Information. Refer to appropriate service information .
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • The mileage has been successfully programmed into the PCM. Test is complete.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals