Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 2500 HD and 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
NOTE:
Diagnose and repair any charging system DTCs before proceeding with this test.

NOTE:
Inspect and test the battery in accordance with the service information before continuing with this test.

NOTE:
Inspect the generator drive belt before continuing with this test.

NOTE:
Inspect the vehicle for aftermarket accessories that may exceed the Generator System output.

NOTE:
Inspect the fuses in the PDC. If an open fuse is found, use the wire diagram/schematic as a guide and inspect the wiring and connectors for damage.
1. Start the engine and allow it to idle.
2. With the scan tool, select View DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
CHECK THE BATTERY NEGATIVE (-) CABLE
1. Turn the ignition on.
2. Measure the voltage between the B (-) cable engine ground and the Battery Positive (-) Post.
  Is the voltage above 0.25 Volt?
  
  Yes
  - Repair the Battery Positive (-) circuit for high resistance.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK THE BATTERY POSITIVE (+) CIRCUIT FOR HIGH RESISTANCE
1. Measure the voltage between the B (+) Terminal at the Generator and the Battery Positive (+) Post.
  Is the voltage above 0.25 volts?
  
  Yes
  - Repair the Battery Positive (+) circuit for high resistance.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 4
GENERATOR CASE GROUND HIGH RESISTANCE
NOTE:
Make sure all testing equipment and cables are clear of any engine parts before starting the engine.
1. Start the engine and allow it to reach operating temperature.
2. Measure the voltage between the Generator case and the Battery Negative (-) post.
  Is the voltage above 0.25 volts?
  
  Yes
  - Repair the Generator Case ground for high resistance.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Intelligent Battery Sensor in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .