LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 416 (5.7L CNG - DTCS P000B To P0203 - 2500 Hd) >> Diagnosis And Testing >> P01B0-Alternative Fuel Level Sensor Performance >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2013 RAM 2500 HD and 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

The Powertrain Control Module (PCM) monitors the fuel volume consumed by the engine when in CNG mode. If the PCM determines that 2.5 gallons of CNG fuel was consumed during this drive cycle or multiple drive cycles and the CNG High Pressure Sensor voltage does not change more than 0.059 volts, the sensor is determined to be stuck and a fault is set. Two trip fault.

scientia non olet · About LEMON Manuals