Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IF THE DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, record and erase Memory Seat Module-Driver (MSMD) DTCs.
3. Cycle the ignition switch from off to on.
4. Move the Seat Switch in the rear vertical position three times.
5. With the scan tool, read MSMD DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (G402) DRIVER SEAT REAR VERTICAL POSITION SENSE CIRCUIT
1. Disconnect the Driver Seat Rear Vertical Adjuster Motor harness connector.
2. Measure the voltage between the (G402) Driver Seat Rear Vertical Position Sense circuit and ground.
  Is the voltage above 11 volts?
  
  Yes
  - Replace the Power Seat Track in accordance with the Service Information. Refer to DESCRIPTION .
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK THE (G402) DRIVER SEAT REAR VERTICAL POSITION SENSE CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the MSMD C5 harness connector.
3. Measure the resistance between ground and the (G402) Driver Seat Rear Vertical Position Sense circuit.
  Is the resistance below 100K Ohms.
  
  Yes
  - Repair the (G402) Driver Seat Rear Vertical Position Sense circuit for a short to ground.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 4
MEMORY SEAT MODULE (MSMD)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and harness connectors between the Driver Seat Rear Vertical Adjuster Motor and the MSMD.
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact in the Driver Seat Rear Vertical Adjuster Motor and MSMD harness connectors.
4. Perform any Technical Service Bulletins that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace and program the MSMD in accordance with the Service Information. Refer to MODULE, MEMORY, REMOVAL .
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .