Communication Pre-Diagnostic Procedure

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Verify that the battery is fully charged before attempting any diagnostic procedure.

1. Check for any Service Bulletins/Recalls that may apply.
2. With the scan tool, read all active DTCs from all modules.
3. Check for BCM configuration, CAN Bus, VIN Missing/Mismatch, battery or ignition related DTCs. If any DTCs are present, perform the appropriate diagnostic procedure before proceeding. Refer to appropriate diagnostic information.
  If none of the above apply, pick the one below that best describes your situation:
  
  If you were referred to this procedure from another module diagnostic section and no other modules are reporting a lost communication DTC against that module:
  - Refer to DIAGNOSIS AND TESTING and perform the Lost Communication with the module that was referenced.
    NOTE:
    Some DTC numbers and naming may not match exactly to those listed in the BCM. Select the DTC that matches the closest.
  If more than one module is reporting a communication DTC against one module:
  - This is an indication of a communication problem with that module. Refer to DIAGNOSIS AND TESTING and perform the No Response from the module that is being reported from the other modules.
  If the reported DTC is not Active:
  - Refer to DIAGNOSIS AND TESTING and perform the Stored Lost Communication DTCs diagnostic procedure.