Rear Brake Hose - 1500 Series

Left and right side procedures are similar.

1. Install prop rod on the brake pedal to keep pressure on the brake system. Holding pedal in this position will isolate the master cylinder from the hydraulic brake system and will not allow brake fluid to drain out of the brake fluid reservoir while the brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
   Fig 1: Locating Rear Junction Block

   Courtesy of CHRYSLER LLC
2. Raise and support the vehicle. Refer to Hoisting , Standard Procedure .
3. Remove the appropriate line connector (1 or 6) from the junction block (2) located on the frame.
   NOTE:

   The right brake line has three push type retainers, and the left brake line has only one push type retainer.

4. Remove the brake line retainer clip(s) (7, left side shown in illustration)
   Fig 2: Locating Antilock Sensor Harness & Routing Clips

   Courtesy of CHRYSLER LLC
5. Remove the antilock sensor harness (1) from the routing clips (2) on the brake hose.
   Fig 3: Locating Brake Hose Retainer Clip Bolt

   Courtesy of CHRYSLER LLC
6. Remove the banjo bolt (4) at the caliper.
7. Remove the brake hose retainer clip bolt (1) located at the frame.
8. Remove the brake line.