LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> PEDAL(S), Brake and/or Accelerator >> Removal >> Pedal Assembly

Pedal Assembly

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The brake pedal is serviced as a complete assembly including accelerator pedal and the bracket.

NOTE:

The views in this procedure are with adjustable pedals. Without adjustable pedals are similar.

Fig 1: Identifying Pedal Components
GC0087347Courtesy of CHRYSLER LLC
  1. Disconnect the negative battery cable.
  2. Remove the brake lamp switch. Refer to SWITCH, Stop Lamp , Removal .
  3. Remove the steering column. Refer to Column , Removal .
  4. Disconnect the electrical connectors.
  5. Remove the brake booster rod to brake pedal retainer clip and discard the clip.
  6. Remove the four brake booster nuts.
  7. If equipped with a manual transmission, remove the clutch master cylinder to clutch pedal clip and pin.
    NOTE:

    If equipped with an automatic transmission a clutch master cylinder block out plate is used in place of the master cylinder and the retaining nuts will still be used.

  8. Remove the two clutch master cylinder nuts.
  9. Remove the three pedal assembly mounting bolts (to instrument panel) and remove the pedal assembly (4) from the vehicle.
scientia non olet · About LEMON Manuals