LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> MASTER CYLINDER, Brake >> Removal >> HYDROBOOST

MASTER CYLINDER, Brake: Removal: HYDROBOOST

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Nut, Electrical Connector, Brake Lines & Master Cylinder
GC0108000Courtesy of CHRYSLER LLC
  1. Remove the brake lines (5) from the master cylinder (3).
  2. Disconnect the electrical connector (1) for the low fluid level.
  3. Remove the mounting nut (4) from bottom of the master cylinder (3).
    Fig 2: Identifying Wiring Box, Mounting Nut & Master Cylinder
    GC0108003Courtesy of CHRYSLER LLC
  4. Unclip the wiring box (3) next to the master cylinder (4) and move out of the way.
  5. Remove the upper mounting nut (2) for the master cylinder.
    NOTE:

    Using care remove the master cylinder directly forward in order not to dislodge the output rod from its seat inside the booster.

  6. Remove the master cylinder (4).
scientia non olet · About LEMON Manuals