LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> BOOSTER, Power Brake, Hydro-Boost >> Removal >> Removal

BOOSTER, Power Brake, Hydro-Boost: Removal: Removal

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Nut, Electrical Connector, Brake Lines & Master Cylinder
GC0108000Courtesy of CHRYSLER LLC
NOTE:

If the booster is being replaced because the power steering fluid is contaminated, flush the power steering system before replacing the booster.

  1. With engine off depress the brake pedal 5 times to discharge the accumulator.
  2. Remove brake lines (5) from master cylinder (3).
  3. Remove mounting nuts (4) from the master cylinder.
  4. Remove the master cylinder (3).
  5. Remove the return hose and the two pressure lines (2) from the hydraulic booster.
  6. From inside the vehicle remove the booster push rod clip, washer and rod remove from the brake pedal.
  7. Remove the brake lamp switch. Refer to SWITCH, Stop Lamp , Removal .
  8. Remove the mounting nuts from the hydraulic booster and remove the booster.
scientia non olet · About LEMON Manuals