Sensor, Crankshaft Position: Installation: 5.7L
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CYLINDER BLOCK - RIGHT / REAR |
| 2 - ELEC. CONNECTOR |
| 3 - MOUNTING BOLT |
| 4 - CKP SENSOR |
- Clean out machined hole in engine block.
- Apply a small amount of engine oil to sensor o-ring.
- Install sensor (4) into engine block with a slight rocking and twisting action.CAUTION:
Before tightening the CKP sensor mounting bolt, be sure the sensor is completely flush to the cylinder block. If the CKP sensor is not flush, damage to the sensor mounting tang may result.
- Install mounting bolt (3) and tighten to 28 N.m (21 ft. lbs.) torque.
- Connect electrical connector to sensor.
- Lower vehicle.