Sensor, Air Temperature, Intake: Removal: 5.7L

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IAT Sensor - 5.7L

Courtesy of CHRYSLER GROUP, LLC

1 - FRONT OF INTAKE MANIFOLD PLENUM

2 - IAT ELECTRICAL CONNECTOR

The intake manifold air temperature (IAT) sensor (2) is installed into the front of the intake manifold air box plenum.

Disconnect electrical connector (2) from IAT sensor.

Clean dirt from intake manifold at sensor base.

Fig 2: IAT Sensor Tab/O-Ring

Courtesy of CHRYSLER GROUP, LLC

1 - IAT SENSOR

2 - SENSOR O-RING

3 - RELEASE TAB

Fig 3: Identifying IAT Sensor - 5.7L

Courtesy of CHRYSLER GROUP, LLC

1 - FRONT OF INTAKE MANIFOLD PLENUM

2 - IAT SENSOR

3 - RELEASE TAB

Gently lift on small plastic release tab (3) and rotate sensor about 1/4 turn counterclockwise for removal.
Check condition of sensor O-ring.