Pedal, Accelerator: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not attempt to separate or remove the Accelerator Pedal Position Sensor (APPS) from the accelerator pedal assembly. The APPS and the accelerator pedal is replaced as an assembly. If the sensor is removed from the pedal, the electronic calibration may be destroyed.

Fig 1: Accelerator Pedal Position Sensor (APPS)

Courtesy of CHRYSLER GROUP, LLC

Position the accelerator pedal assembly on the pedal sled.
Install the lower accelerator pedal mounting bolt (3) and tighten to 7 N.m (5 ft. lbs.).
Install the upper accelerator pedal mounting bolt (2) 7 N.m (5 ft. lbs.).
Connect the 6-way electrical connector at the APPS (1).
If necessary, use a Scan Tool to erase any Diagnostic Trouble Codes (DTC's).