Sensor, Water In Fuel: Installation: Primary
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Drain Valve, Drain Hose, Mounting Screws, Sensor Harness Connector & Filter Housing
NOTE:
The engine has a self-priming low-pressure fuel system. To prime the fuel system, refer to FUEL SYSTEM PRIMING - DIESEL .
- Using a new O-ring, install the Water in Fuel (WIF) sensor (3) and securely tighten the WIF sensor.
- Connect the WIF sensor harness connector (2).
- Start engine and check for leaks.