LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 386 (Vehicle Theft Security (Service Information) - 2500 Hd & 3500 Hd) >> Switch, Hood Ajar >> Removal >> Stand Alone Switch

Stand Alone Switch

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hood Ajar Switch & Mounting Bracket
GC0086783Courtesy of CHRYSLER GROUP, LLC
  1. Unlatch and open the hood.
  2. Disconnect and isolate the negative cable from the battery.
  3. Remove the six plastic push in retainers that secure the upper seal to the upper grille support, the upper radiator cross member and the front fender flanges.
  4. Remove the upper seal from the vehicle.
  5. Working from the top of the mounting bracket (3) on the upper radiator cross member (1), squeeze the two stand alone hood ajar switch latch tabs (5) together far enough to pull the switch (4) upward.
  6. Pull the switch up through the hole in the mounting bracket far enough to access and disconnect the wire harness connector from the switch connector receptacle.
  7. Remove the stand alone hood ajar switch from the vehicle.
scientia non olet · About LEMON Manuals