Stand Alone Switch
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stand alone hood ajar switch (4) near the mounting bracket (3) on the upper radiator cross member (1).
- Route the wire harness connector for the switch through the mounting hole in the mounting bracket from beneath and reconnect it to the switch connector receptacle.
- From the top of the mounting bracket, align and insert the switch through the mounting hole and press it downward until the two integral switch latch tabs snap into place.
- Position the upper seal to the upper grille support and secure it with two plastic push in retainers.
- Align the upper seal to the upper radiator cross member and secure it with two plastic push in retainers.
- Align the upper seal to the front fender flanges and secure it with two plastic push in retainers.
- Reconnect the negative cable to the battery.
- Close and latch the hood.