LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 384 (Ignition System (Service Information) 2500 Hd & 3500 Hd) >> Sensor, Camshaft Position >> Removal >> 6.7L

Sensor, Camshaft Position: Removal: 6.7L

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate both of the negative battery cables.
  2. Remove the left front wheelhouse splash shield (Refer to SHIELD, SPLASH, FRONT WHEELHOUSE ) .
  3. Disconnect the Camshaft Position (CMP) sensor wire harness connector (1).
    Fig 1: Camshaft Position (CMP) connector - 6.7L
    G00590344Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolt (1) and the CMP sensor (2).
    Fig 2: CMP Sensor Removal/Installation - 6.7L
    G00590345Courtesy of CHRYSLER GROUP, LLC
  5. Check the condition of the O-ring seal (2) and replace if necessary.
    Fig 3: CMP Sensor O-ring seal - 6.7L
    G00590346Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals