Sensor, Camshaft Position: Removal: 5.7L

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Camshaft Position Sensor - 5.7L

Courtesy of CHRYSLER GROUP, LLC

The Camshaft Position Sensor (CMP) (3) is located on right side of timing gear/chain cover below generator (1).

Disconnect electrical connector (3) at CMP sensor.

Fig 2: CMP Sensor Removal/Installation - 5.7L V8
Courtesy of CHRYSLER GROUP, LLC
Remove sensor mounting bolt (3).
Carefully twist sensor (2) from timing gear/chain cover.
Check condition of sensor O-ring.