Sensor, Camshaft Position: Removal: 4.7L

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: CMP Location

Courtesy of CHRYSLER GROUP, LLC

The Camshaft Position Sensor (CMP) (2) is bolted to the front/top of the right cylinder head (1).

Raise and support vehicle.
Disconnect electrical connector (4) at CMP sensor.
Remove sensor mounting bolt (3).
Carefully twist sensor from cylinder head.
Check condition of sensor O-ring.