LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 378 (Heated Seats (Service Information) 2500 Hd & 3500 Hd) >> Switch, Heated Seat >> Installation >> Rear

Switch, Heated Seat: Installation: Rear

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Back Side Of Floor Center Console Rear Trim Panel
GC0085470Courtesy of CHRYSLER GROUP, LLC
  1. Install the 2nd row heated seat switch assembly into the floor console rear trim panel. Push the switch firmly into the trim panel until the retaining tabs are fully seated.
  2. If equipped, connect the 2nd row heated seat switches (1), 115 Volt power outlet (3) and the auxiliary audio jacks (2) electrical connectors to the floor console rear trim panel.
    Fig 2: View Of Center Floor Console Rear Trim Panel
    GC0085469Courtesy of CHRYSLER GROUP, LLC
  3. Align the trim panel (3) to the console and insert the bottom tabs into the mounting slots.
  4. Tilt the upper edge of the trim panel (1) forward and apply hand pressure to seat all retaining clips.
  5. Connect the battery negative cable.
  6. Verify 2nd row heated seat system operation.
scientia non olet · About LEMON Manuals