LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 377 (Heated/Cooled Accessories (Service Information) - 2500 Hd & 3500 Hd) >> Pad, Vented Seat >> Installation >> Installation

Pad, Vented Seat: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Seat back shown in illustration. Seat bottom similar.

Fig 1: Vented Seat & Heated Seat Pads
GC0087602Courtesy of CHRYSLER GROUP, LLC
  1. Install the replacement vented/heated seat pad (3) to the seat cushion (1) by placing it directly where the original pad was removed from.
    Fig 2: Vented Seat Pad Flange
    GC0087603Courtesy of CHRYSLER GROUP, LLC
  2. Carefully guide the vented seat pad flange (3) through the opening (2) in the seat back or seat bottom foam.
  3. Connect the heated seat electrical connector.
  4. Install the seat cushion or seat back cover.
  5. Reconnect the negative battery cable.
  6. Verify vented seat system operation.
scientia non olet · About LEMON Manuals