Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
NOTE:
Check for any TSB(s) related to the condition. If a TSB applies, perform the procedure outlined in the TSB before continuing.
1. Turn the ignition on.
  NOTE:
  Make sure the battery voltage is between 10.0 and 16.0 volts.
2. With the scan tool, read the module status.
  NOTE:
  Check the BCM for any active CAN hardware DTCs, perform DTC before proceeding.
  
  Does the scan tool indicate that the module is active on the bus?
  
  Yes
  - The no response condition is not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  No
  - Go To 2
CHECK THE (A943) FUSED B(+) CIRCUIT FOR AN OPEN OR SHORT
1. Turn the ignition off.
2. Disconnect the TPM Module harness connector.
3. Turn the ignition on.
4. Using a 12-volt test light connected to ground, check the (A943) Fused B(+) circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 3
  No
  - Repair the (A943) Fused B(+) circuit for an open or short.
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (Z906) GROUND CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Using a 12-volt test light connected to 12-volts, check the (Z906) Ground circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 4
  No
  - Repair the (Z906) Ground circuit for an open.
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (D93) CAN C(+) BUS CIRCUIT FOR AN OPEN
1. Disconnect the Star Can C IP C11 harness connector.
2. Measure the resistance of the (D93) CAN C Bus (+) circuit between the Star Can C IP C11 harness connector and the TPM Module harness connector.
  Is the resistances below 5.0 Ohms?
  
  Yes
  - Go To 5
  No
  - Repair the (D93) CAN C(+) Bus circuit for an open.
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (D94) CAN C(-) BUS CIRCUIT FOR AN OPEN
1. Measure the resistance of the (D94) CAN C Bus (-) circuit between the Star Can C IP C11 harness connector and the TPM Module harness connector.
  Are the resistances below 5.0 Ohms?
  
  Yes
  - Replace the Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the (D94) CAN C(-) Bus circuit for an open.
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .