LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Audio/Video/Entertainment/Connectivity (Service Information) 2500 Hd & 3500 Hd) >> Antenna, Satellite, Audio >> Removal >> Removal

Antenna, Satellite, Audio: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Lower the rear portion of the headliner as necessary to access underside of antenna (1). Refer to HEADLINER, REMOVAL .
    Fig 1: Disconnecting/Connecting Antenna Cables
    GC0154522Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the antenna cables (1).
  4. Remove retaining fastener.
    Fig 2: Removing/Installing Antenna
    GC0154381Courtesy of CHRYSLER GROUP, LLC
  5. From inside the vehicle, and using a flat bladed tool, depress one of the retaining tabs on the antenna. Push up the one side of the antenna connector (2) through the roof panel. Depress the other side of the connector and remove the antenna (1).