LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 361 (Charging System (Service Information) 2500 Hd & 3500 Hd) >> Generator >> Installation >> 5.7L

Section 361 (Charging System (Service Information) 2500 Hd & 3500 Hd): Generator: Installation: 5.7L

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the generator to the engine and install the two mounting bolts. Tighten to 41 N.m (30 ft. lbs.).
  2. Position the support bracket to the front of the generator and install the bolt and nuts. Tighten to 41 N.m (30 ft. lbs.).
  3. Snap the field wire connector into the rear of the generator.
  4. Install the B+ terminal eyelet to the generator output stud. Tighten mounting nut to 12 N.m (8.8 ft. lbs.).
    CAUTION:

    Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

    CAUTION:

    When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or Refer to the Belt Schematics in ENGINE COOLING SYSTEM - 2500 HD & 3500 HD .

  5. Install the generator drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals